gwj / at91sam9263 · Commits

The current flash emulation code advertises a write buffer size of 16
bytes (1 << 4, according to offset 0x2A of the CFI table). This is
very small compared to normal write buffer sizes, and makes the
process of writing to the flash very slow (at least from U-Boot).

This patch increases this size to 2048 bytes. Except the modification
of the CFI table, the only other required modification is to use
"value" instead of "cmd" to set pfl->counter, because cmd is truncated
to the 8 lower bits of value, while the number of bytes for a write
can now be greater than 255 bytes.

Signed-off-by: Thomas Petazzoni <thomas.petazzoni@free-electrons.com>


git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5454 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5453 c046a42c-6fe2-441c-8c8c-71466251a162

The DIAGNOSE command in the qemu IDE implementation has an error when
use dfor packet devices. 

The status register value is dependant on the drive being a packet
device or not, this patch corrects the returned status.

From the ATA/PI specification (V6 draft):

"If the device implements the PACKET command feature set, the device
SHALL clear bits 6,5,4,3,2 and 0 in the Status register to zero."

A selection of physical devices have been checked and do conform to
the specifications behaviour.

Signed-off-by: Vincent Sanders <vince@simtec.co.uk>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5452 c046a42c-6fe2-441c-8c8c-71466251a162

Replace signalfd with signal handler/pipe.  There is no way to interrupt
the CPU execution loop when a file descriptor becomes readable.  This
results in a large performance regression in sparc emulation during
bootup.
   
This patch switches us to signal handler/pipe which was originally
suggested by Ian Jackson.  The signal handler lets us interrupt the
CPU emulation loop while the write to a pipe lets us avoid the
select/signal race condition.
    
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5451 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5450 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5449 c046a42c-6fe2-441c-8c8c-71466251a162

* Add partial support for the EXS (exception status) register.
* Update SPC after each singlestep exception.
* Remove special treatment of break 8.


git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5448 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5447 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5446 c046a42c-6fe2-441c-8c8c-71466251a162

* break 8 sets ERP to the current insn.
* First shot at S flag single-stepping.
* Make it easier to use the local disasm.


git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5445 c046a42c-6fe2-441c-8c8c-71466251a162

Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5444 c046a42c-6fe2-441c-8c8c-71466251a162

Introduce a max_cpus per-machine variable, allowing individual boards
to limit it's number of CPUs. Check requested number of CPUs in setup
code and exit if it exceeds the supported number for the machine.
This also renders the static MAX_CPUS check obsolete, so remove this
from vl.c.

Signed-off-by: Jes Sorensen <jes@sgi.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5443 c046a42c-6fe2-441c-8c8c-71466251a162

Modify all the machine struct declarations to use C99 initializers.
This patch has no functional changes.

Signed-off-by: Jes Sorensen <jes@sgi.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5442 c046a42c-6fe2-441c-8c8c-71466251a162

This patch adds support for host USB devices discovered via:

/sys/bus/usb/devices/* and opened from /dev/bus/usb/*/*
/dev/bus/usb/devices and opened from /dev/bus/usb/*/*

in addition to the existing discovery via:

/proc/bus/usb/devices and opened from /proc/bus/usb/*/*

Signed-off-by: TJ <linux@tjworld.net>
Signed-off-by: Anthony Liguori <aliguori>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5441 c046a42c-6fe2-441c-8c8c-71466251a162

This adds support for running the sparse checker during the build
process.  Left it off by default for now, build becomes very noisy with
sparse checking turned on as it has to complain alot (partly even in the
system headers!).  The qemu code base needs quite some cleanups before
we should consider turning it on by default.

Signed-off-by: Gerd Hoffmann <kraxel@redhat.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5440 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5439 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5438 c046a42c-6fe2-441c-8c8c-71466251a162

This patch replaces the static memory savevm/loadvm handler with a "live" one.
This handler is used even if performing a non-live migration.

The key difference between this handler and the previous is that each page is
prefixed with the address of the page.  The QEMUFile rate limiting code, in
combination with the live migration dirty tracking bits, is used to determine
which pages should be sent and how many should be sent.

The live save code "converges" when the number of dirty pages reaches a fixed
amount.  Currently, this is 10 pages.  This is something that should eventually
be derived from whatever the bandwidth limitation is.

Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5437 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5436 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5435 c046a42c-6fe2-441c-8c8c-71466251a162

The current savevm/loadvm protocol has some draw backs.  It does not support
the ability to do progressive saving which means it cannot be used for live
checkpointing or migration.  The sections sizes are 32-bit integers which
means that it will not function when using more than 4GB of memory for a guest.
It attempts to seek within the output file which means it cannot be streamed.
The current protocol also is pretty lax about how it supports forward
compatibility.  If a saved section version is greater than what the restore
code support, the restore code generally treats the saved data as being in
whatever version it supports.  This means that restoring a saved VM on an older
version of QEMU will likely result in silent guest failure.

This patch introduces a new version of the savevm protocol.  It has the
following features:

 * Support for progressive save of sections (for live checkpoint/migration)
 * An asynchronous API for doing save
 * Support for interleaving multiple progressive save sections
   (for future support of memory hot-add/storage migration)
 * Fully streaming format
 * Strong section version checking

Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5434 c046a42c-6fe2-441c-8c8c-71466251a162

This patch adds a dirty tracking bit for live migration.  We use 0x08 because
kqemu uses 0x04.

Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5433 c046a42c-6fe2-441c-8c8c-71466251a162

This patch adds a bdrv_flush_all() function.  It's necessary to ensure that all
IO operations have been flushed to disk before completely a live migration.

N.B. we don't actually use this now.  We really should flush the block drivers
using an live savevm callback to avoid unnecessary guest down time.

Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5432 c046a42c-6fe2-441c-8c8c-71466251a162

Live migration happens in the background, but it is useful to make the monitor
command appear as if it's blocking.  This allows a management tool to
immediately know when the live migration has completed without having to poll
the migration status.

This patch allows the monitor to be suspended from a monitor callback which
will prevent new monitor commands from being executed.

Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>



git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5431 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5430 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5429 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5428 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5427 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5426 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5425 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5424 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5423 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5422 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5421 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5420 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5419 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5418 c046a42c-6fe2-441c-8c8c-71466251a162

Forced the constant's width to long long so that it doesn't overflow,
problem spotted by C. W. Betts.


git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5417 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5416 c046a42c-6fe2-441c-8c8c-71466251a162

git-svn-id: svn://svn.savannah.nongnu.org/qemu/trunk@5415 c046a42c-6fe2-441c-8c8c-71466251a162